Nano coating for car body nano armor

"CERAMIC ARMOR COAT" is a ceramic, extremely strong paint protection against negative environmental effects. The unique technology creates a strong protective layer that protects your vehicle from acids, alkalis, salts, rain, dust, and ultraviolet rays. Surfaces covered with "CERAMIC ARMOR COAT" also acquire strong hydrophobic properties, allowing the car's surface to be easier to maintain, wash and clean. A car coated with this product will stay clean and shiny for longer. FIELDS OF USE: Cars, yachts, motorcycles and other vehicles (trains, planes, windsurfers, etc.), any painted and varnished surfaces (car lights, etc.), plastic finishing elements. This product is not suitable for covering chromed, unvarnished painted parts. Newly painted surfaces can be covered no earlier than 2 months after painting. The product is also suitable for covering all types of painted and varnished plastic surfaces. INSTRUCTIONS FOR USE (read the entire instructions before applying the surface): 1. Preparation for coating Before coating the car with this product, the surface must be properly prepared. Recommended preparation: wash the car thoroughly, remove stubborn dirt with a special wiper for the body, polish the body with special products, degrease the surface with a silicone remover, wash again and dry the car until it is completely dry. Make sure that there is no water left in the gaps or trims that could get on the surface during the application (for this we recommend blowing all the water out of the car's trims etc. with a strong air current) If water gets on the coated surface during the application, we recommend re-polishing the wetted area and apply CERAMIC ARMOR COAT again. 2. Surface coating Make sure that the surface is not hot and not exposed to direct sunlight. During application, the temperature should be between +5 and +25 °C. Wear the rubber gloves included in the kit when applying. Before opening the bottle, gently shake the contents and open the cap. Wet the tampon with the product in 4-5 different places: press the tampon to the opening of the neck of the bottle and briefly turn it upside down, as shown in the video instruction on our website. With a moistened swab, rub the area you want to cover in horizontal and vertical movements - make sure there are no uncovered areas. One swab should cover about 1 m2, it should take about 75 seconds. After covering the area with a swab, immediately wipe the surface with one microfiber cloth, and repeatedly wipe with a second microfiber cloth until the surface is completely dry and smooth. You can use both sides of the cloths. Attention: do not leave the surface unwiped, as the nano coating hardens by reacting with air,therefore, it is necessary to wipe off excess product with a microfiber cloth. If the product is not cleaned with cloths and it hardens, visible circles and spots may remain. They can be removed with 2000 grit sandpaper or a sanding tool. If during application the temperature is higher than +25°C and the relative humidity in the air exceeds 50%, apply in areas not larger than 50 x 50 cm and polish with a microfiber cloth at the same time. After covering the entire desired surface, it must be protected from contact with water, dirt, chemicals and friction for 24 hours. The coating is fully formed and hardens 48 hours after application. Microfiber cloths used for coating should not be reused for cleaning lacquered, glossy plastic surfaces. We recommend that you carefully review the video instructions below before covering the car in order to avoid possible mistakes. Product yield